Instruction manual

5
CLICK HERE TO GO THE INDEX
Brother Cartridges
LC04C, LC04M, LC04Y, LC04BK
1. Put a piece of tape over the bottom hole of the cartridge.
2. Use a athead screwdriver to remove the cover by prying up the clip holding the cover
on the cartridge.
3. Using a knife remove the large silver seal.
4. Underneath the large silver seal there are two holes (lling hole and vent hole), use the
eyelet screw to widen the hole closest to the center of the cartridge (not the hole closest
to the edge of the cartridge).
5. Connect the needle to the syringe and ll ink.
6. Insert the syringe into the hole that was located under the large silver seal. Note: You
may feel a slight pressure because the cartridge contains a sponge.
7. Inject about 7 ml. of ink and seal the lling hole and vent hole with a piece of tape.
8. Snap the plastic cover back onto the cartridge the same direction it came o.
9. Rinse the syringe with water and dry between each color rell or store for future use.
10. Remove the tape covering the bottom hole and reinsert the cartridge(s) and run a
priming cycle as per printer instructions.
Note: Immediately rell any empty cartridge
Filling Hole
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.