Instruction manual

59
CLICK HERE TO GO THE INDEX
797-0
1. SKIP THIS STEP if your cartridge is not a Pitney Bowes original cartridge. e original PB
cartridges have a cap which needs to be removed. Using a medium sized at screwdriver,
li the tab as shown in the picture. Once the tab has cleared the top of the cartridge, slide
the cap away from you until it is completely removed from the cartridge.
2. Remove the circular silver seal tabs (not necessary for Nupost compatible cartridges). Pay
careful attention to both areas exposed by removing the silver seals, you will notice that 1
are actually has 2 holes right next to each other, whereas the other area only has 1 hole. In
the area that has 2 holes next to each other, make sure NOT to put ink into the outer hole,
as that is a vent hole and any ink poured in there will leak out the bottom of the cartridge.
3. FOR PITNEY BOWES ORIGINAL CARTRIDGES: Enlarge the 2 lling holes (the one on
the right of the picture shown, and the INNER of the 2 holes on the le of the cartridge as
shown). You can enlarge these holes using an eyelet screw or a small drill bit. Note that you
need to ll BOTH lling holes with ink in order for the cartridge to work. FOR NUPOST
COMPATIBLE CARTRIDGES: ere are 2 lling holes, the one is a self-sealing rubber
hole in the middle of the circle on the le, and the other is to the right of the picture which
needs to be enlarged with an eyelet screw or small drill. Both these holes (the larger self
sealing hole on the le, as well as the hole you have enlarged on the right) need to be lled with
ink.
4. Draw up compatible ink in the syringe, and ll both chambers as positioned in point 4 above.
e larger chamber on the le will hold more ink. Do NOT overll the chambers, especially
the right chamber. If you have lled it to the brink, carefully remove a small amount of ink to
avoid it spilling. You will know when each chamber is full because you will see the ink com-
ing to the top. Stop short of the top for both chambers to avoid spillage.
5. Cover both lling holes with electrical tape, making sure to leave the middle vent hole open
on the Nupost model as shown below.
6. Replace the cap of the cartridge (not needed for Nupost model). If the cartridge is dripping ink,
place it on some paper towels until it has pressurized and stopped dripping. Now you can place
it back in the Pitney Bowes meter.
Pitney Bowes
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.