Instruction manual

58
CLICK HERE TO GO THE INDEX
Pitney Bowes
793-5
1. Peel o the sticker on the top front of the cartridge (original Pitney Bowes
cartridges have a sticker that covers the entire top side of the cartridge, whereas
NuPost Compatible cartridges have a smaller sticker).
2. Underneath the sticker, you will notice at least 1 hole. Locate the hole that is
covered by a silver foil seal tab, this silver seal covers the lling hole. (If you do
not see this hole in your cartridge, please use the illustration to your right to
create a hole to rell the cartridge).
3. Attach the needle to the syringe and draw up 8 ml of compatible ink.
4. Either insert the needle through the silver seal, or remove the seal rst using
a small knife or blade and then insert the needle through the lling hole. (do
NOT insert the needle through any hole that has a rubber protrusion, as indi-
cated by the lower hole in this Nupost compatible cartridge). e lling hole
should provide no initial resistance to your needle other than the seal that lies
above it. Once you insert the needle into the cartridge, you will begin to feel
some resistance due to the sponge inside the cartridge, it is OK to penetrate
this sponge. Push the needle gently through to the bottom of the sponge, and
inject about 8 ml of ink or until the cartridge is full. You will know the car-
tridge is full because the sponge will no longer be able to hold any more ink.
5. Seal the lling hole with electrical tape, and allow the cartridge to sit for a few
minutes over some paper towels in order to allow the ink to settle to the bot-
tom of the cartridge, and for any overow to drip and settle its way out through
the bottom. Once the cartridge is no longer dripping, you can place it back in
the printer.
Create rell hole here
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.