Instruction manual

56
CLICK HERE TO GO THE INDEX
Xerox Cartridges
8R12728
1. Use the eyelet screw to make the lling hole in the small notch on the corner
located next to the “1” shown on the label.
2. Fill the syringe with ink and inject about 8 ml. of ink until the ink tank is full.
3. Use a piece of tape to seal the lling hole, make sure that the tape is stuck to
the cartridge.
4. Rinse the syringe with water and dry for future use, or use with a dierent
color ink.
5. Reinsert the cartridge and run a priming cycle as per printer instructions.
Note: Immediately rell any empty cartridges.
Filling Hole
Under Label
Top and body
of cartridge
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.