Instruction manual
55
CLICK HERE TO GO THE INDEX
Xerox Cartridges
8R7903, 8R7904
1.
e lling holes are located under the plastic cap. e cap is held in place with
a pin at the each corner. Use a thin athead screwdriver or knife to remove the
cap. Important: Do not to damage the sensors on the back of the cartridge.
2.
Connect the needle to the syringe and ll with ink.
3.
Insert the needle into the matching hole of the color to be relled, (see dia-
gram above) and push into the cartridge. Note: You will feel a slight pressure
because the cartridge contains a sponge.
4.
Inject about 10 ml. of ink, per color, into the cartridge until the ink begins to
bubble at the top of the sponge. Important: Do not overll. Keep the sponge
inside the cartridge white.
5.
Rinse the needle and syringe with water and dry between each color relling
or store for future use.
6.
e cover can be put back onto the cartridge by pressing it down.
Cyan
Unused Fill-
ing hole
Yel l ow
Magenta
Black
Sensors
Plastic
Cover
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.