Instruction manual

54
CLICK HERE TO GO THE INDEX
Xerox Cartridges
8R7638
1. Using the included hole making tool make a lling hole in the front of the
cartridge about 1/2” from the top.
2. Connect the needle to the syringe and ll with ink.
3. Insert the lling needle into the hole and aim it towards the center of the car-
tridge.
Note: The cartridge contains a dense sponge made out of felt. As soon as
the needle touches the felt stop pushing in the needle.
4. Inject up to 40 ml. of ink or until ink bubbles at the lling hole.
5. Use either the plug included in the kit or a piece of tape to seal the lling hole.
6. Rinse the syringe and needle with water and dry for future use.
7. Reinsert the cartridge and run a priming cycle as per printer instructions.
Note: Empty cartridges should be relled immediately.
Make 1/8” /3mm
lling hole
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.