Instruction manual
52
CLICK HERE TO GO THE INDEX
Xerox Cartridges
Color Cartridges:
8R12591, 8R7880, 8R882
1.
e lling holes are located under the plastic cap. Use a thin athead screw\driver or
knife to remove the cap. Important: Do not to damage the sensors on the back of
the cartridge.
2.
Connect the needle to the syringe and ll with ink.
3.
Insert the needle into the matching hole of the color to be relled, (see diagram
above) and push into the cartridge. Note: You will feel a slight pressure because the
cartridge contains a sponge.
4.
Inject about 8 ml. of ink, per color, into the cartridge until the ink begins to bubble
at the top of the sponge. Important: Do not overll. Keep the sponge inside the
cartridge white.
5.
Rinse the needle and syringe with water and dry between each color relling or store
for future use.
6.
e cover can be reattached with a piece of tape
Black Cartridges:
8R7881
1.
Use the enclosed eyelet screw to enlarge the lling hole located at the top of the car-
tridge. (Do not remove the cap.)
2.
Connect the needle to the syringe and ll the syringe with 8 ml. of Cartridge & Print
Head Cleaner and inject into the cartridge. Reinsert cartridge into printer and print
5 test pages.
3.
Fill the syringe with ink. Insert the needle into the lling hole and push down into
the cartridge. Inject up to 20 ml. of ink or until the cartridge is full.
Note: Immediately rell any empty cartridges.
Sensors
Magenta
Cyan
Yel l ow
Filling Hole
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.