Instruction manual

50
CLICK HERE TO GO THE INDEX
Pitney Bowes Cartridge
769-0
1. Put a piece of tape over the exit hole located on the bottom of the cartridge
2. e lling hole is located on the back of the cartridge and must be widen using
the included eyelet screw
3. Connect the needle to the syringe and ll with FLUORESCENT RED ink.
4. Insert the syringe into the lling hole all the way down into the cartridge.
Note: This cartridge contains a sponge so you may feel a slight pressure.
5. Use your thumb to hold the tape in place while injecting 4 ml. of ink into the
cartridge.
6. Rinse the syringe with water and dry for future use.
7. Reinsert the cartridge(s) and run a cleaning cycle as per postage machines
instructions.
Note: Immediately rell any empty cartridges.
Filling hole
Outlet hole
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.