Instruction manual

49
CLICK HERE TO GO THE INDEX
Okidata Cartridges
52110001, 52110002, 52110003, 52110004
1. e lling hole is located under the label as shown. Just peel back the label
leaving it still connected to the cartridge, do not remove completely.
2. Use the provided eyelet screw to drill a lling hole on the top of the
cartridge(s) opposite side of the sponge.
3. Connect the needle to the syringe and ll with ink.
4. Insert the needle into the lling hole and inject about 5 ml of ink.
5. Use the provided plug to seal the hole. Note: If the cartridge has been empty/
dry, the sponge will no longer accept any ink which will cause the cartridge
to leak. Pull the label back into place and use a piece of tape to hold it in place.
6. Rinse the syringe with water and dry between each color rell or store for
future use.
7. Reinsert cartridge back into the printer and run 1 - 3 cleaning cycles as per
printer instructions.
Note: Immediately rell any empty cartridges
Filling hole
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.