Instruction manual
48
CLICK HERE TO GO THE INDEX
Okidata Cartridges
Black Cartridge:
52109301
1.
Use the enclosed eyelet screw to enlarge the lling hole located at the top of the car-
tridge. (Do not remove the cap.)
2.
Connect the needle to the syringe and ll the syringe with 8 ml. of Cartridge & Print
Head Cleaner and inject into the cartridge. Reinsert cartridge into printer and print 5
test pages.
3.
Fill the syringe with ink. Insert the needle into the lling hole and push down into the
cartridge. Inject up to 20 ml. of ink or until the cartridge is full. Note: Immediately
rell any empty cartridges.
Color Cartridge:
52109302
1.
e lling holes are located under the plastic cap. Use a thin athead screw driver or
knife to remove the cap. Important: Do not to damage the sensors on the back of the
cartridge.
2.
Connect the needle to the syringe and ll with ink.
3.
Insert the needle into the matching hole of the color to be relled, (see diagram above)
and push into the cartridge. Note: You will feel a slight pressure because the car-
tridge contains a sponge.
4.
Inject about 8 ml. of ink, per color, into the cartridge until the ink begins to bubble at
the top of the sponge. Important: Do not overll. Keep the sponge inside the car-
tridge white.
5.
Rinse the needle and syringe with water and dry between each color relling or store
for future use.
6.
e cover can be reattached with a piece of tape.
Magenta
Yel l ow
Cyan
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.