Instruction manual
47
CLICK HERE TO GO THE INDEX
Lexmark Cartridges / Dell Cartridges
Items needed: gloves, hand-drill, cartridges, paper towels.
Note: You will need the Lexmark 100A version. Some models may require a new replacment
chip to succesfully reset the cartridge.
Lexmark offers for sale two different versions of the same cartridge: The regular version
(#100) is not rellable. It is the “Return Program” or “Rebate” cartridge. Supposedly,
when you buy this cartridge you agree to return the empty cartridge to Lexmark. In
return, Lexmark gives you roughly $5 off the retail list price of the cartridge. The “A”
version (#100A) can easily be relled. However, the price of the cartridge is roughly $5
higher than the regular version, so most people unknowingly buy the regular version. If
you want to rell, you will need “A” version cartridges.
1.
Put the cartridge on some paper towels in an area where you can tolerate a spill.
2.
Fill the syringe with 12 ml. of black ink or 5 ml of Color Ink .
3.
Pierce with the needle into the label where black meets white. (You can rub your
nger over the label and feel the hole underneath.) See illustration.
4.
Push the needle at least half way down into the sponge and Very SLOWLY inject ink
into the sponge.
5.
When nished, leave the pierced hole open (this will just be a vent hole).
6.
Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.
Or print the following pages:
For best results, leave cartridge in printer for 8 hours after relling so the ink can satu-
rate the entire sponge.
Pierce needle here
LEXMARK 100A, 108A, 150A, 200A
Chip Replacement Option
To replace the chip, peel back the top
label until the chip is fully exposed.
Pry it from its current position, remove
it, and then replace it with a new one in
the same orientation as the original or
previous chip.
Once the chip has been replaced, place
the label back on the cartridge. Your car-
tridge should be ready for use.
CHIP
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.