Instruction manual
46
CLICK HERE TO GO THE INDEX
Lexmark Cartridges / Dell Cartridges
1.
Peel back the label from the top of the cartridge to expose the rell
holes of the cartridge. (If the illustration on the right differ from
your cartridge model, use 3 toothpicks and poke each hole to de-
termine its color)
2.
Fill the syringe with 15 ml of black ink (5 ml for each color on
color cartridges).
3.
Insert the needle into the cartridge (corresponding with the cor-
rect color ink) and ll. If to much ink is inserted, pull back on the
syringe handle to pull 1 ml out.
IMPORTANT: When relling, only puncture the top of the sponge
in the cartridge, about 1/8 to 1/4 inch. Puncturing to the bottom
may cause leakage in the cartridge.
4.
e cartridge will function better keeping the label o the top of
the cartridge, allowing air to enter the cartridge from the top and
thereby allowing ink to ow better through the cartridge. Keep the
top of the cartridge exposed to air (do not put tape over the holes).
Make sure to keep the cartridges up right when transporting them
back to the printer
5.
Rinse the syringe with water and dry between each color rell or
store for future use.
6.
Reinstall the cartridge and run 1 - 3 test pages as per printer in-
structions. If necessary leave the cartridge in printer for up to 24
hours to allow ink to ow to the print head.
NOTE: Cartridges that are not relled right away may and can dry
with time. For the best results, rell right after the cartridges are de
-
pleted.
BLACK
MAGENTA
YELLOW CYAN
LEXMARK
#3, #4A, #14A, #23A, #28A, #32,
#34, #36A, #42A, #44
LEXMARK
#1, #2, #5A, #15A, #24A, #29A, #33,
#35, #37A, #41A. #43
NOTE: If your cartridge is part of Lexmark’s re-
cycle program, then the relling holes might not be
viewable. In this case you can drill a hole in the
same area’s indicated above to rell the cartridge.
DELL
MK990, MK992,
Series 5 , Series 7, Series 8,
Series 9, Series 15,Series 11
DELL
MK991, MK993,
Series 5, Series 7, Series 8,
Series 9, Series 15,Series 11
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.