Instruction manual

45
CLICK HERE TO GO THE INDEX
Lexmark Cartridges
18C0031, 18C0032, 18C0033, 18C0034, 18C0035
Black Cartridges:
1. Use the enclosed eyelet screw to enlarge the lling hole located at the top of the
cartridge. (Do not remove the cap.)
2. Connect the needle to the syringe and ll the syringe with 8 ml. of Cartridge &
Print Head Cleaner and inject into the cartridge. Reinsert cartridge into printer
and print 5 test pages.
3. Fill the syringe with ink. Insert the needle into the lling hole and push down into
the cartridge. Inject up to 20 ml. of ink or until the cartridge is full. Note: Immedi
-
ately rell any empty cartridges.
Color Cartridges:
1. e lling holes are located under the plastic cap. Use a thin athead screwdriver
or knife to remove the cap. Important: Do not to damage the sensors on the back
of the cartridge.
2. Connect the needle to the syringe and ll with ink.
3. Insert the needle into the matching hole of the color to be relled, (see diagram
above) and push into the cartridge. Note: You will feel a slight pressure because the
cartridge contains a sponge.
4. Inject about 8 ml. of ink, per color, into the cartridge until the ink begins to bubble
at the top of the sponge. Important: Do not overll. Keep the sponge inside the
cartridge white.
5. Rinse the needle and syringe with water and dry between each color relling or
store for future use.
6. e cover can be reattached with a piece of tape.
Magenta
Cyan
Yel l ow
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.