Instruction manual

39
CLICK HERE TO GO THE INDEX
Relling the Black Cartridge:
1. Use the enclosed eyelet screw to create the lling hole at the top of the cartridge. Picture
A, on the right, illustrates where the rell hole should be created.
2. Fill the syringe with ink. Insert the needle into the lling hole and push down into the car -
tridge. Inject up to 9 ml of ink into the cartridge. It is always better to under ll than over
ll any cartridge. You can always add more ink later.
3. Once your cartridge has been lled, remove the needle from the cartridge and plug the top
of the cartridge with the plugs provided in your rell kit. Please make sure to seal the plug
tight so that no extra air goes in our out of the cartridge as it prints. You will also avoid
any spills as well.
Relling the Color Cartridges:
1. Use the enclosed eyelet screw to create the lling hole at the top of the cartridge. Picture B,
on the right, illustrates where the rell hole should be created.
2. Fill the syringe with ink. Insert the needle into the lling hole and push down into the
cartridge. Inject up to 4 ml of ink into the cartridge. It is always good practice to under ll
than over ll any cartridge. You can always add more ink later.
3. Once your cartridge has been lled, remove the needle from the cartridge and plug the top
of the cartridge with the plugs provided in your rell kit. Please make sure to seal the plug
tight so that no extra air goes in our out of the cartridge as it prints. You will also avoid
any as well.
Rell hole
NOTE: On OEM HP cartridges, there is a small dimple located near the
HP emblem as illustrated on picture B. If this dimple is on your
OEM HP cartridges, please create the relling hole through it
Picture B shows a relling hole which was created through the dimple
of a yellow HP OEM cartridge.
Reinstalling the Cartridges
Reinstalling:
1. Open the lid to your printer.
2. Place your relled cartridge into the cradle that corresponds with the color of the
tank.
3. Close the lid to your printer.
4. A prompt will then display on your printer screen saying “Original HP Ink De-
pleted”.
5. On your printer will be a circle of buttons with “OK” in the middle and arrow
keys. Press the right arrow key.
6. A prompt will then display on your printer screen saying “Attention”.
7. Press the “OK” button on your printer.
NOTE: e ink levels will not show on the screen. However, once the volume of
ink has been depleted from the replaced tank, the printer will not allow you to
print any further until the tank has been relled again.
Some printers may require a new chip after rell
A
B
Rell hole
Hewlett Packard Cartridges
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.