Instruction manual

38
CLICK HERE TO GO THE INDEX
Hewlett Packard Cartridges
C6634A, C6635A
1. Drill lling holes on the top of the cartridge (as shown below le) or pry o
the cartridge top as shown below right. Do the procedure that is easier for you.
Use the hole making tool included in the kit, drill each lling hole on the top
of the cartridge wide enough to t the needle as shown below le. Or use a at
-
head screwdriver to pry o the top.
2. Connect the needle to the syringe and ll with the ink. Note: All 3 ling holes
must be relled in the black cartridge.
3. Insert the syringe through the lling hole and push all the way into the car-
tridge. Note: You may feel a slight pressure because the cartridge contains a
sponge.
4. Slowly inject up to 6 ml. of ink, per chamber, then seal the lling holes using a
piece of tape.
5. Rinse the syringe with water and dry for future use, or use with a dierent
color ink.
6. Reinsert the cartridge(s) and run a test page as per printer instructions.
Note: Immediately rell any empty cartridges.
Black
Magenta
Cyan
Yel l ow
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.