Instruction manual
36
CLICK HERE TO GO THE INDEX
Hewlett Packard Cartridges
C1806A, C1807A, C1808A, C1809A
1.
Remove the Mylar ink bag from the cardboard covering. Note: (This Mylar
ink bag is very delicate and must be handled with care).
2.
Use both hands when holding the top of the Mylar bag and use both thumbs
to pry the hose cap o of the connector. (Pop o the connector the same way
you would pop o the cap of an aspirin bottle. Be very careful not to damage
the connector.) Make certain not to misplace or damage the O-ring. It must be
in the same position shown below before the hose cap assembly can be rein
-
stalled.
3.
Connect the needle to the syringe and ll with ink.
4.
Hold the bag upright and inject up to 60 ml of ink or until 3/4 full. Do not
ll completely because you need room to install the hose cap assembly. Note:
(After lling do not squeeze the Mylar bag as this will cause ink to squirt out
of the connector.
5.
Hold the top of the Mylar bag and using both thumbs reinstall the hose cap
assembly. You can grasp the block at the base where the assembly is installed
into the Mylar bag. Make sure the hose cap assembly is rmly attached to the
connector. You will feel two clicks when reinstalling the hose cap assembly.
6.
Put the Mylar bag back into the cardboard covering and install into machine.
7.
Rinse the syringe and needle with water between each color relling and dry
for future use.
Note: Empty cartridges should be relled immediately.
Base of
Connector
Assembly
Connector
Mylar Bag
Hose Cap
Assembly
Connector
O-Ring
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.