Instruction manual

34
CLICK HERE TO GO THE INDEX
HP Cartridges
HP 701
1. Peel back the label from the top of the cartridge to expose the vent hole of
the cartridge.
2. Fill the syringe with 15 ml of black ink (5 ml for each color on color car-
tridges).
3. If the vent hole is to small, use the provided drill to increase the width. Be
sure to only drill through the plastic and not the sponge. en insert the
needle into the cartridge and ll slowly. If to much ink is inserted, pull back
on the syringe handle to pull 1 ml out.
IMPORTANT: When relling, only puncture the top of the sponge in the
cartridge, about 1/8 to 1/4 inch. Puncturing to the bottom may cause leak
-
age in the cartridge.
4. Stick the label back in place, if the label has been destroyed, use duct tape or
electrical tape (Tape is optional).
5. Rinse the syringe with water and prepare it for storage.
6. Reinstall the cartridge and run 1 - 3 test pages as per printer instructions.
If necessary leave the cartridge in printer for up to 24 hours to allow ink to
ow to the print head.
NOTE: Cartridges that are not relled right away may and can dry with time.
For the best results, rell right after the cartridges are depleted.
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.