Instruction manual
30
CLICK HERE TO GO THE INDEX
Hewlett Packard Cartridges
51645A, 51645G, 51640A, 51640C, 51640M, 51640Y, 51644C,
51644M, 51644Y, C6615DN , C6615AN
1.
Turn the cartridge upside down and using a peel back the plastic lm covering
the stainless steel ball bearing as shown below.
2.
Using a screwdriver push the ball bearing into the cartridge.
3.
Connect the needle to the syringe and ll with the correct color ink. Impor-
tant: Do NOT insert the needle more than 1 inch into the cartridge as you may
purchase the bag inside the cartridge.
4.
Inject 20 ml. of ink into the hole.
5.
Squeeze the sides of cartridge while sealing the lling hole with the included
plug, make sure that the plug is seated ush against the cartridge.
6.
Allow cartridge to sit with the print head down for at least 2 minutes to draw
out any excess ink and equalize the pressure in the cartridge. Important: Do
not leave the cartridge resting on a paper towel. This will cause your car-
tridge to slowly empty itself..
7.
Rinse the syringe with warm water and dry between each color rell or store
for future use.
8.
Reinsert the cartridge and run a priming cycle as per printer instructions.
Note: Immediately rell any empty cartridges.
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.