Instruction manual
28
CLICK HERE TO GO THE INDEX
Hewlett Packard Cartridges
51626A, 51629A, 51626G, 51629G,
51633M, C6614AN, C6628AN
1.
Put a piece of tape over (Aerator “B”) on the bottom of the cartridge. is aerator must
be sealed tightly to prevent leaking. - See diagram.
2.
Aerator “C” is located in the center of the top of cartridge. DO NOT STICK THE
NEEDLE IN THIS HOLE.
3.
If you have a cartridge that has a ball bearing in the top corner of the cartridge then
simply push in the ball bearing with a pointed object such as a screwdriver.
4.
If you have a cartridge that does not have this ball bearing; a hole must be made in the
top corner of the cartridge- see diagram. Use the hole making tool included in the kit
or an exacto knife or a drill bit to make this hole. is hole must be made perfectly
round.
5.
Remove the Hole Making Tool from its packaging then remove the cover from the tool
to expose the blade. CAREFUL! Blade is sharp. Firmly hold the handle of the tool and
begin twisting the tool into the top corner of the cartridge. Continue twisting until it
pierces the plastic cover. Once the plastic to is pierced, making the rest of the hole will
go very quickly.
IMPORTANT: Do not make a hole as big as the tool itself. The plug provided must
t tightly in order for a perfect air tight seal.
6.
Connect the needle to the syringe and pull back on the plunger to ll with cartridge
and printhead cleaner. Inject approximately 2 ml of cleaner. It is not necessary to seal
the cartridge. Let the cartridge sit for about 2 minutes. To remove the cleaner, turn the
cartridge over and let it drain out of the lling hole.
7.
Now turn the cartridge upright on a paper towel and ll with 20 ml. of ink through the
lling hole on the top corner of the cartridge.
8.
Squeeze the sides of the cartridge while sealing the hole with the plug included. Op
-
tional: To insure that it is sealed airtight, cover the plug with a piece of electrical
tape.
9.
Rinse the syringe with water and dry for future use.
10.
Now remove the tape over (Aerator “B”).
11.
If the cartridge continues to drip ink, Insert ONLY the tip (no more than
1/8 inch) of the needle into (Aerator “C”), hold the cartridge over a sink or
paper towels. Pull back on the plunger of the EMPTY syringe to 2 ml and
push down on the plunger to pump 2 ml of air into cartridge. Important: Do
NOT insert the needle more than 1/8 inch into aerator C as you will damage
the cartridge.
12.
Ink will now drip from the nozzles. Blot the nozzles with the tissue until ink
stops dripping.
13.
Reinsert cartridge into printer and run several test cycles until print quality
is restored.
Note: Allow the cartridge to sit outside the printer overnight to restore print
quality. Note: Immediately rell any empty cartridges.
Aerator “B”
Aerator “C”
Filling Hole
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.