Instruction manual
27
CLICK HERE TO GO THE INDEX
Epson Cartridges
A Chip Resetter (sold separately) is needed for the following cartridges:
T124120, T124220, T124320, T124420, T125120, T125220, T125320,
T125420, T126120, T126220, T126320, T126420, T127120, T127220,
T127320, T127420, T128120, T128220, T128320, T128420
1.
It is important to understand the sections of this cartridge before relling. Please
study diagram closely.
2.
Using the eyelet screw, create a hole (see illustration to the right). Keep the screw
centered when drilling the hole.
3.
Using Tape, seal the air path to the cartridge as shown on the right.
4.
Connect the needle to the syringe and ll with the correct color ink.
5.
Plug the hole using the silicone or rubber plug, and then penetrate the needle
through the plug. is will create an air tight seal while relling. Inject about 12
ml. of ink slowly into the lling hole until the cartridge is almost full. You may
need to pull back on the syringe and then push in slowly to get all the ink in.
6.
Once nished remove the tape from you used to cover the air path in step 3.
7.
Rinse the syringe with water and dry for future use, or use with a dierent color
ink.
8.
Follow the resetting instructions from the resetter before inserting the cartridge
into printer.
Note: Immediately rell any empty cartridges.
Create Hole Here
Cover with Tape
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.