Instruction manual
26
CLICK HERE TO GO THE INDEX
Epson Cartridges
A Chip Resetter (sold separately) is needed for the following cartridges:
T0431, T0441, T0442, T0443, T0444, T0481, T0482, T0483, T0484,
T0485, T0486, T0540, T0541, T0542, T0543, T0544, T0545, T0546,
T0547, T0548, T0549, T0601-T0604
1.
It is important to understand the sections of this cartridge before relling. Please
study diagram closely.
2.
Using the eyelet screw, create a hole (see illustration to the right). Keep the screw
centered when drilling the hole.
3.
Connect the needle to the syringe and ll with the correct color ink.
4.
Insert the needle into the newly created hole. Inject about 12 ml. of ink slowly
into the lling hole until the cartridge is almost full.
5.
Wipe the lling hole clean and dry and then insert a silicon plug. Depending on
the sealing plug you receive, you may need to widen the hole to accommodate
the new plug. Be sure to seal it air tight (not sealing it air tight could cause leak-
age while printing).
6.
Rinse the syringe with water and dry for future use, or use with a dierent color
ink.
7.
Follow the resetting instructions before inserting the cartridge into printer.
Note: Immediately rell any empty cartridges.
Create Rell hole
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.