Instruction manual

25
CLICK HERE TO GO THE INDEX
Epson Cartridges
A Chip Resetter (sold separately) is needed for the following cartridges:
T0321,T0322, T0323, T0324, T0331, T0332, T0333, T0334, T0335, T0336,
T0341, T0342, T0343, T0344, T0345, T0346, T0347, T0348, T0422, T0423,
T0424, ICD Y21
1. Turn the cartridge upside down and using a paper clip or a similar object, pierce
through the label into the cartridge of the proper lling hole (as shown below).
2. Connect the needle to the syringe and ll with ink.
3. Inject about 5 - 7 ml. of ink into the lling hole until the cartridge is almost full.
Be aware that the needle will only go into the cartridge about 3/8 of an inch.
4. Use the tape dot to seal the lling hole, make sure it is completely sealed.
5. Rinse the syringe with water and dry for further use, or use with a dierent color
ink.
6. Follow the resetting instructions before inserting cartridge into printer.
Note: Immediately rell any empty cartridges.
Filling Hole
Do not use
this hole
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.