Instruction manual

24
CLICK HERE TO GO THE INDEX
Epson Cartridges
S020093, S020097, S020110, S020193,
S020187, S020189, S020191, S020089, S020093,
S020108, S020047, S020049, S020097, S020034, S020036, S020138,
T001, T003011, T003012, T005011,
A Chip Resetter (sold separately) is needed for the following:
T007201, T008, T008201, T009, T009201, T013, T014, T015201,
T016201, T017, T018, T019201, T020201, T026, T027, T028, T029,
T036120, T037020, T040120, T041020
1. Put a piece of tape over each outlet hole(s) at the bottom of the cartridge.
2. Connect the needle to the syringe. Before lling the syringe with ink, use the
needle tip to pierce through the label to create the lling hole. en ll the
syringe with the appropriate color ink.
3. Slowly inject approximately 8 ml. of ink, per color, until the cartridge is full.
4. Use tape to seal the hole(s) made in the top of the label.
5. Rinse the syringe with water and dry between each color rell or store for
future use.
Follow this step for cartridges WITHOUT the smart chip:
6. Leave the tape on the outlet hole(s) and insert the cartridge into the printer
and run 1 - 3 cleaning cycles as per printer instructions. It may be necessary
to leave cartridge in printer for up to 24 hours to allow ink to ow to the print
head.
NOTE: If cartridge is relled before it is completely empty this time is greatly
reduced.
Black
Cyan
Light Cyan
Light Magenta
Yel l o w
Magenta
Cyan
Magenta
Yel l o w
Black
Cyan
Magenta
Yel l o w
Photo Cartridge
Fill Hole
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.