Instruction manual
18
CLICK HERE TO GO THE INDEX
1. Remove the label from the top of cartridge
2. Using the drill tool, widen the rell holes for each color. Please use the illustrations on the
right for color guidance.
3. Attach the needle to syringe and load syringe with 6 ml of ink for each color in the color car-
tridge or 20 ml for the black cartridge.
4. Insert needle into corresponding color and penetrate the sponge inside. Insert the needle only
a 1/4 of an inch in.
If the needle penetrates to the bottom of the cartridge, the cartridge will leak and is not
salvageable.
5. SLOWLY inject the ink into the cartridge. Reverse the process and pull about 1 ml of ink if it
has spilled out the top of the cartridge.
6. Repeat steps 5, 6, 7, 8 until all colors have been injected.
7. Clean o the top of the cartridge. Place tape over the top of the cartridge so it covers every
hole.
8. Use a pin and put a small hole (vent hole) through the tape for each hole on the top of the
cartridge.
This is important, don’t skip this step. The cartridge must be vented to atmosphere or it will
not work.
9. Reinstall in printer and run one or two cleaning cycles until the cartridge begins to print cor-
rectly.
PG-30/PG-40/PG-50
PG-210/PG-240/PG-245
PG-440
CL-31/CL-41/CL-51
CL-211/CL-241/CL-246
CL-441
CL-52
BLACK
MAGENTA
PHOTO CYAN
BLACK
PHOTO MAGENTA
CYAN
YELLOW
Canon Cartridges
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.