Instruction manual

ManualsBrandsCanon ManualsComputer equipment7822A001 - i 950 Color Inkjet Printer

CLICK HERE TO GO THE INDEX

Canon Cartridges

Method #2

Use electrical or duct tape to seal the Air Vent found on the top of the cartridge.

Note: Make sure tape is completely covering the vent.

Remove the label partially, only to expose the ball bearing underneath. en use a screw

driver or an L. tool to push the ball bearing into the cartridge. is will give access to the

lling hole.

Connect the needle to the syringe and ll with ink.

Use your nger as a plug by covering the outlet port. Keep your nger on the outlet port

until you have nished relling and the rell hole is plugged. If you let go any time earlier,

ink may and can spill out of that outlet.

Inject about 10 ml. of ink into the lling hole or until the ink chamber is full. Be sure to

leave enough room in the ink chamber for the silicon plug, it will create pressure when

inserted.

Put a silicone plug in the rell hole to seal it, make sure it is air tight. If extra silicone from

the plug is sticking out, you may trim it down to a practical size. Be sure to leave enough

to make it easy for you to remove the next time you wish to rell the cartridge.

Remove your nger from the outlet (small drops may leak out, but once the cartridge pres

sure stabilizes itself, it will stop) and remove the tape from earlier o the vent.

Rinse the syringe with water and dry for future use, or use with a dierent color ink.

Reinsert the cartridge and run a priming cycle as per printer instructions.

Note: If the cartridge continuously leaks, place the cartridge on its side until the dripping

stops. Also, check the seal on the cartridge to make sure it is airtight.

Outlet PortSponge Chamber

Ink Chamber

Rell Hole

(Ball Bearing)

Air Vent

Push in the ball bearing (may require

some force)

All trademarks are property of their respective owners. Uni-Kit

has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.

All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.