Instruction manual

ManualsBrandsCanon ManualsComputer equipment7822A001 - i 950 Color Inkjet Printer

CLICK HERE TO GO THE INDEX

Canon Cartridges

BCI-3e , BCI-3, BCI-5, BCI-6, Cli-8, PGI-5, PGI-220,

CLI-221, PGI-225, CLI-226, PGI-250, CLI-251

(All Colors)

NOTE: Canon Resetter may be required to have the

cartridges resgister as full upon installation.

Method #1

Using a manual drill or the small

drill provided with your rell kit,

drill through the plastic cas-

ing on the side of the cartridge.

Drill enough to break through

the plastic. Do not drill into the

sponge area beyond the inner

plastic casing.

Once the hole has been created, use the syringe to penetrate

through the sponge, and guide the needle into the ink chamber

as shown in the illustration to the le. Slowly inject the ink into

the chamber until 1/2 of it has been lled. Do not ll to the

chamber more than the recommended amount. Doing so

will cause more ink to ow into the sponge area, forcing ink to

exit through the nozzle port (Area where the ink ows out of

the cartridge).

Once the cartridge has been lled, careful pull the needle out of the cartridge. It is recommended

that you use hot glue to seal the hole created, however, you can use silicon to cover the hole, and

help complete the seal with some type of instant glue. Be sure to allow the cartridge seal to dry

before inserting it into the printer. Placing the cartridge into the printer to early may break the

seal and cause the cartridge to leak.

Note: Make sure to seal the hole completely and not leave any cracks that would cause leaking.

All trademarks are property of their respective owners. Uni-Kit

has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.

All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.