Instruction manual

13
CLICK HERE TO GO THE INDEX
Canon Cartridges
BCI-60, BCI-61, BCI-62
1. e lling holes are located under the label as shown. Just peel back the label
leaving it still connected to the cartridge, do not remove completely.
2. Use the provided eyelet screw to widen the lling hole(s) in the top of the
cartridge(s).
3. Connect the needle to the syringe and ll with ink.
4. Insert the needle into the widen lling hole. Note: This cartridge has a
sponge so you may feel a slight pressure. Inject about 10 ml. of ink, per
color until the ink bubbles up.
5. Pull the label back into place and use a piece of tape to hold it in place.
6. Rinse the syringe with water and dry between each color rell or store for
future use.
7. Reinsert cartridge back into the printer and run 1 - 3 cleaning cycles as per
printer instructions.
Note: Immediately rell any empty cartridge
Cyan
Filling Hole
Magenta
Filling Hole
Yellow
Filling Hole
Black
Filling Hole
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.