Instruction manual

11
CLICK HERE TO GO THE INDEX
Canon Cartridges
BJI-201BK HC, BJI-201BK, BJI-201C, BJI-201M, BJI-201Y
1. With the cartridge upside down, using a screwdriver, push in the ball bearing that seals
the lling hole. NOTE: There are several versions of these cartridges. One version
has the lling hole under the label on the top of the cartridge. Another version does
not have a ball bearing at all. In this case it would be necessary to make a hole for
the needle to be inserted. Make this hole in the same spot where the ball bearing
would be located, as shown below. Seal hole with the plug provided.
2. Connect the needle to the syringe and ll with ink.
3. Inject about 5 ml. of ink into the lling hole until the tank is full.
4. Use the included plug to seal the lling hole, make sure that the plug is sitting ush in
the cartridge. Additional Note: If the cartridge has been empty/dry, the sponge will
no longer accept any ink which will cause the cartridge to leak.
5. Rinse the syringe with water and dry for future use, or use with a dierent color ink.
6. Reinsert the cartridge and run a priming cycle as per printer instructions.
Note: Immediately rell any empty cartridges.
Filling Hole
Outlet Hole
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.