Instruction manual

6
CLICK HERE TO GO THE INDEX
Brother Cartridges
LC41C, LC41M, LC41Y, LC41BK
1. Stand the cartridge on a towel or ink spillable table. Using the eyelet screw provided,
begin twisting the screw into the front of the cartridge (see illustration to the right).
Continue twisting until it pierces the plastic..
2. Connect the needle to the syringe and ll with ink.
3. Insert the syringe into the hole and inject about 20 ml. of ink
4. Seal the lling hole with one of the included tape dots or a piece of duct tape.
5. Rinse the syringe with water and dry between each color rell or store for future use.
LC25Bk, LC25C, LC25M, LC25Y
1. Use the eyelet screw to remove the white plug located next to the exit hole. e plug
does not need to be removed completely since the white plug and the exit hole plug are
connected.
2. Connect the needle to the syringe and ll with ink.
3. Insert the syringe through the lling hole which is found where the white plug was
removed.
4. Inject up to 8 ml. of ink (this cartridge is transparent so you will see the ink level) then
reseal the cartridge with the plug that was removed from step 1. Make sure that the
small plastic tip of the plug sits back into the lling hole.
5. Rinse the syringe with water and dry for future use, or use with a dierent color ink.
6. Reinsert the cartridge(s) and run a priming cycle as per printer instructions.
Note: Immediately rell any empty cartridge
Filling Hole
Outlet Hole
Creat Rell Hole
© All rights reserved, Easy Group, LLC. Version 4.2
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.