Installation guide

Protocol Settings
5-5
5
Using a TCP/IP Network
If the machine is restarted after DHCP, BOOTP, or RARP settings are specified, the TCP/IP Settings screen
displays the IP address setting values obtained from the DHCP, BOOTP, or RARP server. (If the IP address,
host name, and domain name have been previously set, these will be overwritten by the setting values
obtained from DHCP, BOOTP, or RARP.)
If you use DHCP without the DNS dynamic update function, it is recommended that an identical IP address
be assigned to the machine at all times. (If the IP address is not identical, the host name for the machine will
not correspond to the IP address.)
4 On the TCP/IP Settings screen, press [ DNS Settings] → [DNS Server Address
Settings].
5 In <IPv4>, specify the following.
If you want to use dynamic DNS updating, enter the IPv4 address of the DNS server in [Primary DNS
Server].
If you do not want to set up a secondary DNS server, enter <0.0.0.0>.
If you set [BOOTP] or [DHCP] to 'On' in step 3, the IP address of a DNS server you set manually will be
overwritten.
•
•