Installation guide
TCP/IP Network Setup Procedures
5-2
5
Using a TCP/IP Network
TCP/IP Network Setup Procedures
To use a TCP/IP network, it is necessary to perform the following procedures.
1
Protocol Settings (See “Protocol Settings,” on p. 5-3.)
Specify the protocol settings. To specify the settings, use:
The machine's control panel
The Remote UI (via a web browser)
Canon utilities ( NetSpot Device Installer, etc.)
•
•
•
2
Computer Settings for Printing/Sending a Fax (See e-Manual > Network.)
Specify the settings for each computer you use for printing or sending a fax. (Optional equipment is required to print or send a fax from a
computer. For the equipment needed, see “Optional Equipment and System Requirements for Connecting to a Network,” on p. 3-2.)
3
Computer Settings for a File Server (See “Setting Up a Computer as a File Server,” on p. 5-30.)
Specify the settings of the computer receiving data sent from the machine. (Optional equipment is required to send data if you are using
the imageRUNNER 3245/3235/3230/3225. For the equipment needed, see “Optional Equipment and System Requirements for Connecting
to a Network,” on p. 3-2.)
It is recommended that steps 1 and 3 above be performed by the network administrator.
The machine or optional printing equipment does not come with printer driver software that can be used on a UNIX
platform. (Use LPD to set up a printer in UNIX.)
As the fax option does not come with fax driver software for the UNIX platform, it is not possible to send a fax from
a UNIX platform.
•
•
•