Installation guide

List of Error Messages
3-98
3
Troubleshooting
# 852
Cause An error occurred because the main power switch was turned OFF while a job was being
processed.
Remedy Check to see if the main power switch is turned ON. Try processing the job again, if necessary. (See
“Main Power and Control Panel Power,” on p. 1-14.)
# 853
Cause 1 When trying to print a large number of pages, the job is not performed due to insufficient
memory resources.
Remedy 1 Reduce the number of pages to print, or perform the print job again when no other jobs are
reserved.
Cause 2 The job could not be processed, because it was canceled from the printer driver while the print
data was being sent to the machine.
Remedy 2 Try printing again.
Cause 3 The spool memory is full when Use Spooler in Network Settings in System Settings (from the
Additional Functions screen) is set to 'On', therefore, data received from the host could not be
spooled.
Remedy 3 Set Use Spooler in Network Settings in System Settings (from the Additional Functions screen) to
'Off', an d try sending the print data again. (See e-Manual > Network.)
Cause 4 The maximum number of receivable data exceeds the receive limit. (See e-Manual > Mail Box,
Send/Fax.)
Remedy 4 Try printing the documents again after all current jobs are complete. If you still cannot print, check
the sent data.
Cause 5 The number of secured documents exceeded the maximum limit that can be reserved at a time.
Remedy 5 Print or erase the secured documents that are stored in the machine, and try printing again.(See
e-Manual > Print.)