Owner`s manual

Using the Radio

Setting the Alarms

This unit has dual alarms that can be set to different times and different sources (Buzzer, Radio,

iPhone/iPod). The frequencies of each alarm can be set to Daily, Weekdays, and Weekend.

 The unit must be in the OFF position.

 Press and hold the ALARM button until the Alarm 1 Source (image of a bell = Buzzer/Beeper)

appears and flashes. Adjust by using the VOL + or VOL – button (Buzzer/Beeper, Radio, or

iPhone/iPod).

 Press the >>| button, the Frequencies section of Alarm 1 will appear and flash. Adjust by using

the VOL + or VOL – button (Weekdays, Daily, and Weekend).

 Press the >>| button, the Hour section of the Alarm 1 time will appear and flash. Adjust by

using the VOL + or VOL – button.

 Press the >>| button, the Minute section of the Alarm 1 time will appear and flash. Adjust by

using the VOL + or VOL – button.

 Press the >>| button, the Volume section for Alarm 1 will appear and flash. Adjust by using the

VOL + or VOL – button.

 Press the >>| button to go to Alarm 2 section. Follow the same steps above to set Alarm 2.

 The |<< or >>| buttons can be used to go back or forward between the Alarm 1 and Alarm 2

settings.

 At any point in the process the OK button can be pressed to exit and confirm changes.

Arming, Disarming, and Reviewing the Alarm (Alarm On and Off)

Important: Alarms are not automatically armed when set. Active alarms are indicated by alarm icons

on the display.

 Press to ALARM button to arm or disarm the desired Alarm sequence (Alarm 1, Alarm 2, Alarm 1

and Alarm 2, and OFF).

 If Alarm 1 or Alarm 2 appears on the display they’re active, press the ALARM button to disarm

them if desired.

 To review the alarm, use the ‘Setting the Alarms’ instructions above.

Snooze Operation

Press the SNOOZE button when the alarm begins to sound. The alarm will be silenced for five (5)

minutes then sound again. The SNOOZE button can be pressed until the alarm is disarmed.

Resetting the Alarm to come on the Next Scheduled Day

When the alarm is sounding, press the ON/OFF button to stop the alarm and reset it to come on the

next scheduled day.