Owner`s manual

6
www.cannondownriggers.com
Installation
Installing the Base on Your Boat
Decks up to 7/16” thick
Where access to the underside
of the deck is not available, the mounting base can be
mounted using wellnuts. Use the base as a template
to mark locations and drill four wellnut clearance holes.
Mount the base using four 1/4-20 x 1-1/2” truss head
screws and four wellnuts. Tighten the screws so the
wellnuts are fi rmly compressed as pictured.
Decks thicker than 7/16”
For decks thicker than 7/16”, or
where the underside of the deck is accessible, mount
the base with screws, nuts, and washers. Use the base
as a template to mark the locations and drill four 9/32”
holes. Use four 1/4-20 x 2” truss head screws and four
each fl at washers and nuts. Fasten the base to the deck
as pictured. NOTE: Wellnuts
SHOULD NOT be used
on decks thicker than 7/16”.
Decks up to
7/16” Thick
Decks Thicker
Than 7/16”
Thick
Downrigger Mounting on Boats
A downrigger should be mounted wherever it is
easy to operate and observe. You want to be able to
see your fi shing rod and to react quickly. So, choos-
ing a good location to mount your downrigger on your
boat is very important.
Due to the great variety of boats available,
mounting your downrigger can be a diffi cult decision.
Cannon has a complete line of mounting and fi shing
accessories to aid in your fi shing experience. Before
making any permanent changes to your boat consider
what accessories might be used in your application.
Arrows Indicate
Typical Mounting
Locations