Owner`s manual

20
www.cannondownriggers.com
Digi-Troll 10 Display
When the power cord is plugged in, press the power button on the keypad to turn on the downrigger. In normal us-
age, the display will indicate the depth of the weight in feet.
(Note: A negative depth indicates distance above the water surface).
During programming of special features, the display is used to indicate various settings.
Digi-troll 10 Keypad
The Digi-troll 10’s key pad has eight keys located below the display.
Power
The ON/OFF key functions:
1) Turn the Digi-troll ON - Simply press and release.
2) Turn the Digi-troll OFF - Press and hold power button for three seconds.
MENU
The Menu moves the display through up to eight
screens for programming (see section on programming
for details). After 7 seconds of inactivity on the key pad,
the screen reverts back to the weight line out display.
UP
During manual operation, this key raises the weight
when pressed. In programming mode, the UP key
increases numeric values.
DOWN
During manual operation, this key lowers the weight
when pressed. In programming mode, the DOWN
key decreases numeric values.
WATER ZERO
The water zero key provides a reset option for
depth. When pressed and held, the line out count
will reset to zero.
MENU
The menu key provides access to all programming
submenus.
RUN
This key is typically used to execute a function after
selected using the menu system.
SELECT
Use the Select key to set or display the pre-pro-
grammed weight depths when in the Depth screen.
To move the weight to any of the depths indicated,
press the RUN key. Another function of the Select
is to step through sub-menus when you are setting
certain programmable parameters.
AUTO UP
Press AUTO UP to raise the weight to the water
zero set point at any time. AUTO UP uses the
speed 5 regardless of your setting and cancels any
other mode of operation (bottom following, cycling,
etc.) when used.
Getting Started