Owner`s manual

19
www.cannondownriggers.com
Transducer Cable Routing
After mounting the transducer, route the transducer cable to your Digi-Troll. Connect the transducer cable to the
transducer plug at the back of the downrigger. Be sure not to damage the cable jacket. Keep the cable away from
ignition, tachometer, alternator and other electrical wiring to prevent interference. Do not cut, splice or shorten the
cable. Coil the excess and secure it in place. The transducer cable NEEDS to be connected before turning the unit
on.
Connector removal or cable splicing voids the product warranty.
Once the transducer is mounted and connected to your Digi-Troll 10, the display will show the bottom depth under
SONAR DEPTH on the display.
GETTING STARTED
Operating the Digi-troll 10
The Digi-troll 10 offers you the most advanced features available in a downrigger.
• Variable Positive Ion Control.
• Large LCD digital display for weight depth and easy programming.
• Networking operation allowing you to chain several Digi-Troll 10s together for bottom following with only one
transducer. (Optional transducer and interfacing cable required)
• Cycling mode allows the weight to be cycled between two programmable depths.
• Store fi ve pre-programmed weight depths that can be selected at the touch of a key.
• AUTO-UP key to quickly raise the weight to water surface.
• Bottom depth monitor mode allows your downrigger to be used as a depth fi nder (optional transducer required).
• A permanent storage memory to retain all the settings.
• Variable speed operation
• High effi ciency motor
• Compatibility with Cannonlink and Humminbird fi shfi nders (1100, 900, 700, or Matrix Series).
• Display of the Humminbird depth on the Cannon LCD screen (using Cannonlink).
TRANSDUCER INPUT
CIRCUIT BREAKER
POWER CABLE
FIGURE 28
DISPLAYED SONAR DEPTH
FIGURE 29
Getting Started