Technical data

'F
., .
'.,~% f
Coincide its:
. ,
"P ~: -"?
and remove.
colnclde the red dot and guide Pln.
Prri. , ."*,
Uses of Lenses
Changing Lenses *There is a pre-set aperture lever at the
back end of the lens which opens and closes
In removing the lens from the camera, after
the aperture. when the lens is removed, be
turning the bayonet ring of the lens to the left,
sure to always put on the dust cap so as to
take out the lens.
protect the aperture lever.
In mounting the lens' match the red dot Of the
If interchangeable lenses are changed while
lens to the red dot on the camera mount. Turn
the CdS actuating is in locked position,
the bayonet ring to the right and fasten.
the
preset aperture lever cannot be connected
When mounting, turn the bayonet ring of
to the coupling part on
the camera body and
the lens sufficiently
to the left and coincide the
the pre.set aperture will not function.
Be sure
red dot and guide
pin of the lens.
to unlock the
CdS actuating lever when chang-
e Do not change your lens in a strong light.
ing interchangeable lenses.
When changing your lenses
have the replace-
* Do not touch the pellicle mirror or the cou-
ment lens at hand. Then quickly change the
pling section of the aperture. When
not in Use
lenses in the shade.. . or use your shadow as
for a
long time, protect the pellicle mirror by
a shield from direct light.
putting on the flange cap.
31