GB INSTRUCTION BOOKLET BUILT-IN COOKTOPS
Important warnings and tips for use IMPORTANT! This manual constitutes an integral part of the appliance. It must be kept intact and within easy reach during the entire life of the cooktop. Please carefully read this manual and all the instructions contained herein before using the appliance. Keep any spare parts supplied with the appliance. Installation must be carried out by a qualified technician and in compliance with current regulations.
COOKTOP CHARACTERISTICS Warnings: This appliance is intended to be built-in on furniture. The installation class is type 3 for the gas part and type Y for the electric part. The furniture must be resistant to temperatures up to at least 90°C. For correct installation, see the relative section and the reference drawings. The use of a gas cooking appliance leads to the production of heat and humidity in the room in which it is installed.
To restore operation, move the knob to position section. and repeat the igniting operations described in the next Using burners with safety valves o o Turn the knob of the gas tap to the maximum supply position, then press and hold down for about 45 seconds. Release the knob and adjust the flame by turning the knob until reaching the desired intensity. Warning: The ignition device cannot be operated for more than 15 seconds.
Using the grates The cooktop grates have been designed to make the use of the product convenient and safe. We recommend that you check, before each use, the exact positioning and stability of the grate on the cooktop. Furthermore, check that the rubber supports are always intact and arranged correctly. Grate for small cookware (Fig. 2) - Optional This is placed only over the grate of the auxiliary burner (the smallest one) when using cookware with a small diameter in order to prevent it from tipping over.
Fixing the cooktop The cooktop must be fixed to the furniture as follows: Position the appropriate sealing gasket provided with the cooktop along the external perimeter of the hole made in the furniture according to the diagram in fig. 5, so that the ends of the strips are perfectly joined to one another without overlapping. Arrange the cooktop in the hole on the furniture, making sure that it is centered.
The gas feed connector is a G1/2" threaded concentric reducer. (Fig.13) For ISO R7 connections, the gasket is not necessary. For ISO R228 connections, the head washer provided must be inserted. When the connection operations are finished, check the seal of the connections using a soap solution.
MAINTENANCE The appliances do not require particular maintenance, nevertheless it is recommended to have them checked at least once every two years. If the knobs become difficult to turn or the odour of gas is present, close the general tap and contact technical service. The defective tap should be replaced together with the gasket.
GAS DATA Gas type G30 G31 Gas pressure 28-30/37 mbar Burners Auxiliary power inputs Max (kW) Min (kW) 1,00 0,37 Ø injectors 0,50 Semi-rapid 1,75 0,50 0,65 Rapid 3,00 0,90 0,85 Triple-crown 3,8 3,80 1,70 0,98
Fig.1 Fig.3 Fig.2 Fig.
Fig.5 Fig.6 Fig.
Fig. 8 Fig. 9 Fig. 10 Fig.
Fig.14 Fig.
H01A4760
