User Manual

!
16
! Pressing and holding the ECO 40-60 and
20°C buttons for 3 to 6 seconds will allow
you to select two additional normative
programmes, STANDARD COTTON
40°C (press and hold - button C) and
STANDARD COTTON 60°C (press and
hold - button D).
! After selecting the programme, the green
LED on the on/off button on the control
panel will stop flashing and become fixed.
About 1 second after the cycle selection,
there will be a first, short acoustic signal
that confirms the command has been
received correctly and the selected
programme is starting.
! After the wash cycle has been chosen,
the door lock will become active. To open
the door, the appliance must be paused
or the switch-off procedure started. At the
end, it will still be necessary to wait 1
minute before opening the appliance
door.
! At any time, 20 seconds after starting the
chosen programme, in Remote control
disabled mode, it is possible to pause
the appliance from the command panel,
by pressing for 1 second on the "STAR"
cycle button.
! After selecting the programme, the green
LED on the on/off button on the command
panel will start flashing. To confirm the
selection and about 1 second after
pressing on the "STAR" cycle button,
you will hear a short acoustic signal.
! To open the door, wait about 1 minute
after pressing on the "STAR" cycle
button.
X1
After
60 s
1s
! Press the "STAR" cycle button again to
resume the programme from where it left
off.
! To switch off the appliance, press and
hold the ON/OFF button for 3 seconds.
3s
! After selecting, the green LED on the
on/off button on the command panel will
change from fixed to off.
! To open the door, wait about 1 minute
after pressing on the ON/OFF button.
For safety reasons, in some phases of
the wash cycle, the door can only be
opened if the level of the water is
below the door’s lower rim and the
temperature is below 45°C. If these
conditions are met, you have to wait
for 1 minute before you can open the
door.
Additional programmes that can
be selected from the command
panel
Pause mode
Switching off