Operation Manual

32
ENGLISH
2.1 SETTING THE CLOCK
• When the appliance is connected to the domestic power supply for the first time, or after a power cut,
four dashes will appear on the display (----).
In order to set the time of day, proceed as described below:
CHAPTER 2 – USING THE CONTROLS AND SETTING THE MODES
Press the Clock key (3).
(The hours flash on display)
1
Set the desired time by tur-
ning the Time knob (8).
(The hours flash on display)
2
Press the Clock key (3) again.
(The minutes flash on display)
3
Set the desired minutes by tur-
ning the Time knob (8)
(The minutes flash on display)
4
Press the Clock key (3) again.
(The display shows the time set)
5
• If you wish to change the hour on the dial once it has been set, press the Clock key (3) before procee-
ding to set the new time as described above.
• It is possible to display the current time even after starting the mode set, by pressing the Clock key (3) (the
time is displayed for 2 seconds).
GB 6-09-2001 14:00 Pagina 32