EN User instructions DFI 85 S
Congratulations! Contents Thank you for choosing a Candy appliance; quality dishwashers which guarantee high performance and reliability. Candy manufacture a vast range of domestic appliances: washing machines, washer/dryers, cookers, microwave ovens, ovens and hobs, refrigerators and freezers. Ask your dealer for the catalogue with the complete range of Candy products.
Safety Instructions INSTALLATION (Technical notes) Please read the instructions in this booklet carefully because they contain important information on how to install, use and maintain your dishwasher safely as well as containing useful tips on how to make the most of it. Keep this booklet safe for future reference. Important: when the appliance is located on a carpet floor, attention must be paid to ensure that there is no obstruction to the bottom vents.
Water connection Connecting the outlet hose The inlet and drain hoses can be directed to left or right. The dishwasher can be connected to either cold or hot water, as long as it is no hotter than 60 °C. Water pressure must be between 0,08 MPa and 0,8 MPa. If the pressure is below the minimum consult our service department for advice. The inlet hose must be connected to a tap so that the water supply can be cut off when the machine is not in use (fig.1 B).
Water softener unit Loading the salt Depending on the source of the supply, water contains varying amounts of limestone and minerals which are deposited on the dishes leaving whitish stains and marks. The higher the level of these minerals present in the water, the harder the water is. The dishwasher is fitted with a water softener unit which, through the use of special regenerating salt, supplies softened water for washing the dishes.
Loading dishes Adjustment of the upper basket If 27 cm to 31 cm plates are normally used, load them onto the lower basket after the upper basket has been placed in its upper position and proceed as detailed below: 1) Turn the front stops A outwards. 2) Take out the basket and remount it in the upper position.
A standard daily load is represented in Figs. 1, 2 and 3. 1 E A C B D Upper basket (Fig. 1) A = soup plates B = dinner plates C = dessert plates D = saucers E = cups F = glasses F 12 international place load (Ref. EN 50242). Correct loading for the upper basket is indicated in Fig. 4 and for the lower basket in Fig. 5. Fig. 6 cutlery basket. 4 G B E C D H C C 2 A B C D I F H A Upper basket (Fig.
7 Cutlery basket (fig. 7) Information for the test laboratories. The cutlery basket is made with two detachable parts which will enable various loading options. The two parts can be detached by sliding the left section away from the right section. General programme comparison (see programmes selection) Ref. EN 50242 Standards: 1) Upper basket position: low 2) Normal load 3) Shine setting: 5 4) Economy button pressed 5) Amount of detergent: – 8 gr for pre-wash – 22 gr for wash.
Filling the rinse aid container 4 3 FULL EMPTY dark light The rinse aid container can be found to the right of the detergent container: it has a capacity of about 130 ml (Fig A "3"). Turn the cap (3) anticlockwise and pour enough liquid to last several washes, up to the maximum level shown. Replace the cap. The rinse aid, which is automatically released during the last rinsing cycle, helps the dishes to dry quickly and prevents spots and stains forming. It is always advisable to use rinse aid.
General hints Cleaning and maintenance Selecting the programme This dishwasher offers you a wide range of wash programmes so that you can choose the most suitable according to the type of dishes and how dirty they are. Refer to the PROGRAMME LIST to choose the most suitable programme. The outside of the cabinet can be cleaned with a non-abrasive cleaning agent suitable for a gloss finish. The dishwasher does not require special maintenance, because the tank is selfcleaning.
Both the door lining and the tank lining are in stainless steel; however, should spots caused by oxidation occur, this is probably due to a high level of iron salts presents in the water. The spots can be removed with a mild abrasive agent; never use chlorine based materials, steel wool, etc. Description of the control D WHEN CYCLE IS FINISHED After every wash it is essential to turn off water supply and to switch off the machine by pressing the On/Off button to the off position.
Before starting a new programme, you should check that there is still detergent in the dispenser. If necessary, top up the dispenser. Selecting the programmes and special functions Aquaprotect – Protected incoming water pipe Use in conjunction with programme guide Setting a programme Open the door and press the I button; the 5 programme selection indicator lights start flashing to show that the machine is waiting for a selection to be made.
PROGRAMME SELECTION 65°C Normal Once a day - for normal soiled pans and any other items that have been left all day for washing. • • • • • 55°C Regular Suitable for heavily soiled items that are to be washed straight after a meal. 50°C Eco Energy Saving Programme suitable for normal soiled items. Using detergents with enzyme. • • • • • • • • • Eco Energy Saving Programme suitable for normal soiled items. Using detergents with enzyme. Programme standardised to EN 50242.
FAULT Identifying minor faults Warning! Before removing any panel: 1. Turn the knob to STOP. 2. Pull the electric plug out. Should the dishwasher fail to operate, before contacting the Service Centre, make the following checks: FAULT CAUSE CAUSE REMEDY See causes for no.
La Ditta costruttrice declina ogni responsabilità per eventuali errori di stampa contenuti nel presente libretto. Si riserva inoltre il diritto di apportare le modifiche che si renderanno utili ai propri prodotti senza compromettere le caratteristiche essenziali. Le constructeur décline toute responsabilité pour les éventuelles erreurs d’imprimerie contenues dans le présent mode d’emploi.
03.02 - 41003716.
