EN
Thank-you for choosing a Candy washing machine. We are confident it will loyally assist you in safely washing your clothes, even delicates, day after day. Environmental conditions This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
l This appliances is intended to be used in household and similar applications such as: - Staff kitchen areas in shops, offices and other working environments; - Farm houses; - By clients in hotels, motels and other residential type environments; - Bed and breakfast type environments. A different use of this appliance from household environment or from typical housekeeping functions, as commercial use by expert or trained users, is excluded even in the above applications.
foam rubber pads should not be dried in the washer dryer. WARNING: never stop a washer dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. l Fabric softeners, or similar products, should be used as specified by the fabric softener instructions. l Oil-affected items can ignite spontaneously, especially when exposed to heat sources such as a washer dryer.
l When moving, do not lift the grounded. Otherwise, seek qualified professional assistance. washing machine by the knobs or detergent drawer; during transport, never rest the porthole on the trolley. We recommend two people lift the washing machine. l Please do not use converters, multiple cords. sockets or extension l In the event of fault and/or malfunction, turn off the washing machine, close the water faucet and do not tamper with the appliance.
2. INSTALLATION l Cut the tube straps, being careful 1 not to damage the tube and power cord. A B A B l Unscrew the 2 or 4 screws (A) on the back and remove the 2 or 4 shims (B) as illustrated in figure 1. B B A A l Close the 2 or 4 holes using the plugs included in the instruction envelope. l If the washing machine is built-in, 2 after cutting the hose straps, unscrew the 3 or 4 screws (A) and remove the 3 or 4 shims (B).
Hydraulic connections EN 3 l Connect the water tube to the faucet, only using the drain tube supplied with the washing machine (fig. 3). DO NOT OPEN THE FAUCET. l Some models may include one or more of the following features: 4 l HOT&COLD (fig. 4): water mains connection settings with hot and cold water for higher energy savings. Connect the grey tube to the cold water faucet and the red one to the hot water faucet.
l Level the appliance using the feet as 8 illustrated in figure 8: a. turn the nut clockwise to release the screw; b. rotate the foot to raise or lower it until it adheres to the floor; c. lock the foot, screwing in the nut, until it adheres to the bottom of the washing machine. l Plug in the appliance. A B WARNING: contact the Customer Service Centre should the power cord need replacement.
Load tips Before using a drying programme… WARNING: when sorting laundry, make sure: l SAVE energy and time by selecting a - have eliminated metallic objects such as barrettes, pins, coins, from laundry; - to have buttoned pillow cases, closed zips, tied loose belts and long robe ribbons; - to have removed rollers from curtains; - to have carefully read clothing washing labels; - to have removed any persistent stains using specific detergents.
4. MAINTENANCE AND CLEANING To clean the washing machine exterior, use a damp cloth, avoiding abrasives, alcohol and/or solvents. The washing machine does not require any special care for ordinary cleaning: clean drawer compartments and the filter; some tips on how to move the machine or on long periods of disuse are provided below. Drawer cleaning l We recommend you clean the drawer to avoid accumulating additive residue.
6. CONTROLS AND PROGRAMS This washing machine automatically adapts the level of the water to the type and quantity of washing. This system gives a decrease in energy consumption and a sensible reduction in washing times. EN 5. QUICK USER GUIDE A Program selection l Turn on the washing machine and select the required program. L l Adjust the washing temperature if necessary and press the required "option" buttons.
l Switch off the washing machine by turning the selector to OFF. WARNING: Don’t touch the display while inserting the plug because the machines calibrates the systems during the first seconds: touching the display, the machine couldn’t work property. In this case, remove the plug and repeat the operation. The programme selector must be returned to the OFF position at the end of each cycle or when starting a subsequent wash cycle prior to the next programme being selected and started.
l This button allows you to pre-programme the wash cycle to delay the start of the cycle for up to 24 hours. l To delay the start use the following procedure: SPIN SELECTION button - Set the required programme. l By pressing this button, it is possible to reduce the maximum speed, and if you wish, the spin cycle can be cancelled. - Press the button once to activate it (h00 appears on the display) and then press it again to set a 1 hour delay (h01 appears on the display).
l Once the programme has been selected the indicator light will automatically show the stain level set for that programme. l Selecting a different stain level the relevant indicator will light up. - NIGHT CYCLE l This option reduces the intermediate spin speed to 400 rpm, where applicable, increase the water level during rinsing and keep the laundry immersed in water after the final rinse, in order to spread the fibre sevenly.
The display’s indicator system allows you to be constantly informed about the status of the machine. 2 3 4 5 6 7 2) SPIN SPEED 2 11 This show the spin speed of the selected programme that can be changed or omitted by the relevant button. 1 3) WASH TEMPERATURE 8 9 10 3 1) DOOR LOCKED INDICATOR LIGHT This show the washing temperature of the selected programme that can be changed (where allowed) by the relevant button.
5) STAIN LEVEL 5 9) DELAY START { 9 l Once the programme has been selected, the indicator light will automatically show the stain level set for that programme. l Selecting a different stain level the relevant indicator will light up. This flashes when delay start has been set. 10) Kg Check (function active only on Cotton and Synthetics programmes) 6) EXTRA RINSES 10 { l During the first minutes of the cycle, the 6 The indicator lights show the extra rinses selected by the relevant button.
} The appliance calculates the time to the end of the selected programme based upon a standard loading. During the cycle, the appliance corrects the time according to the size and composition of the load. 11 The indicators display the type of the drying programme. Timed drying programmes They may be used to select timed drying programmes. Automatic drying programmes Extra dry programme (suitable for towels, bathrobes and bulky loads).
Table of programmes 1 2 TEMP.°C kg * (MAX.) PROGRAM Recommended Max.
Please read these notes: * Maximum load capacity of dry clothes, according to the model used (see control panel). INFORMATION FOR THE LABORATORIES (Ref. EN Standards) TEST 50229 ( ) Washing (Only for models with liquid detergent compartment) When only a limited number of articles have stains which require treatment with liquid bleaching agents, preliminary removal of stain can be carried out in the washing machine.
Programmes selection To clean different types of fabrics and various levels of dirt, the washing machine has specific programs to meet every need of washing (see table of programmes). Rapid 14 Min / 30 Min / 44 Min A complete washing cycle (wash, rinse and spin). This programme is particularly suited to slightly dirty cottons and mixed fabrics. With this programme it is recommended to use only 20% of the detergent normally used to avoid waste. Whites Made to have a perfect washing.
l Drying guidance advice is general, but l The washer dryer can perform the practical experience of using the product will help you to achieve the best drying results. following types of drying: - Low temperature drying programme recommended for mixed fabrics (synthetics/cotton) synthetic fabrics ( symbol on programme dial). l We recommend setting a lower drying time than indicated, when first using the appliance in order to establish the degree of dryness required.
l Turn the programme dial to the more l When the programme is finished the word suitable drying programme for your laundry. "End" will appear on the display. After 5 minutes the appliance will go into standby mode (on certain models, the display will show two lines). l Select the degree of dryness that you require choosing one of 3 automatic programmes: l After the programme has finished please Extra dry programme (suitable for towels, bathrobes and bulky loads).
same stationery position throughout the cycle until it ends. l At the end of the wash phase the display will show the drying time remaining. You cannot exceed the maximum dryable load of laundry indicated in the programme table, otherwise the laundry will not be dried satisfactory. l The washer dryer will then complete the entire drying programme. l The drying programme indicator will be - Washing l Open the drawer and put in the correct amount of detergent.
9. CUSTOMER SERVICE CENTRE AND WARRANTY If you believe the washing machine is not working correctly, consult the quick guide provided below with some practical tips on how to fix the most common problems. Problem Possible causes and practical solutions The washing machine does not work/start Make sure it is correctly plugged in. Make sure power is on. Check whether the required program was correctly selected and to have correctly started the machine.
Warranty The product is guaranteed under the terms and conditions stated on the certificate included with the product. The warranty certificate must be duly filled in and stored, so as to be shown to the Authorised Candy Service Centre in case of need. - cloudier rinse drain water: This effect is tied to the suspended zeolites which do not have negative effects on rinse efficiency.
fkhldsk
fkhldsk
- GVWT - 14.
