User Manual

DELAY START button

Appliance start time can be set with this button, delaying the start by 3, 6 or 9 hours.

Proceed as follows to set a delayed start:

Select a programme (Wait that a “Spin” indicator light will go on).

Press "Delay Start" button (each time the button is pressed the start will be delayed by 3, 6

or 9 hours respectively and the corresponding light will blink).

Press "Start/Pause" to commence the Delay Start operation (the indicator light associated

with the selected Delay Start time stops blinking and remains ON).

At the end of the required time delay the programme will start.

To cancel the Delay Start function :

press the "Delay Start" button until the indicator lights will be off and the programme can be

started manually using the "Start/Pause" button or switch off the appliance by turning the

programme selector to "OFF" position.

Warning: If there is any break in the power supply while

the machine is operating, a special memory stores the

selected programme and, when the power is restored, it

continues where it left off.

SPIN SELECTION button

The spin cycle is very important to remove as much water as possible from the laundry without

damaging the fabrics. You can adjust the spin speed of the machine to suit your needs.

By pressing this button, it is possible to reduce the maximum speed, and if you wish, the spin cycle

can be cancelled (the spin speed indicator light are off).

To reactivate the spin cycle press the button until you reach the spin speed you would like to set.

To prevent damage to the fabrics, it is not possible to increase the speed over that which is

automatically suitable during the selection of the program.

It is possible to modify the spin speed without to pausing the machine.

Note:

The machine is fitted with a special electronic device, which

prevents the spin cycle should the load be unbalanced.

This reduces the noise and vibration in the machine and so

prolongs the life of your machine.