Washing machine Instructions for use GC 2D
General safety rules – This appliances is intended to be used in household and similar Introduction applications such as: • Staff kitchen areas in carefully shops, ofÄother cesinformation and other Please read these instructions for use and all enclosedworking with the environments; washing machine. • Farm houses;in a safe place for future reference or for any future owners.
– After installation, the appliance must be positioned so that the plug is accessible. Page –Contents The maximum load capacity of dry clothes depends on the model used (see control panel). Introduction 2 –General To consult the product Äche please refer to the manufacturer delivery notes 4 website. Safety notes 4 Quick start instructions 5 Safety controls or maintaining the washing machine, unplug 6 the –Description Before ofcleaning Programme Table 12 appliance and turn off the water faucet.
Contents Page General safety rules General delivery notes Quick start Description of controls Programme Table Programme selector Detergent drawer Detergents, washing aids and amounts to use Useful advice for the user The main wash Cleaning and routine maintenance Investigating malfunctions Technical data Setting up + installation 2 5 5 6 12 14 16 17 19 20 22 24 26 27 BEFORE SWITCHING ON THE APPLIANCE MAKE SURE IT IS CORRECTLY INSTALLED AND THAT THE FIXING SCREWS ARE REMOVED AS SHOWN IN PAGE 27.
General delivery notes Please check that the following items are delivered with the appliance: - Instruction manual - Certificate of guarantee - Inlet hose Check that no damage has occurred during transit, and if so, call your nearest Authorised Technical Support Service agent. Quick start Washing - Open the door by using the handle “A” (Fig.
Description of controls Fig.
Door handle Press the finger-bar inside the door handle to open the door. Programme Start light A B This lights up when the START button has been pressed. C “START/PAUSE” button Press to start the selected cycle . NOTE: When the "Start/Pause" button has been pressed, the appliance can take few seconds before it starts working.
The option buttons should be selected before pressing the "Start/Pause" button. D ALLERGY CARE button By pressing this button you can activate a special new wash cycle in the Cotton and Mixed Fabrics programs, thanks to the new Sensor System. This option treats with care the fibres of garments and the delicate skin of those who wear them.
“DELAY START” button F This button allows you to pre-programme the wash cycle to delay the start of the cycle for up to 24 hours. To delay the start use the following procedure: Set the required programme.
H “DIGITAL” Display 4 3 1 2 The display’s indicator system allows you to be constantly informed about the status of the machine: 1) SPIN SPEED Once the programme has been selected, the maximum spin speed allowed for that programme appears on the display. Pressing the spin button will reduce the speed by 100 rpm each time the button is pressed. The minimum speed allowed is 400 rpm, or it is possible to omit the spin by pressing the spin button repeatedly.
M Buttons indicator light These light up when the relevant buttons are pressed. If an option is selected that is not compatible with the selected programme then the light on the button first flashes and then goes off. PROGRAMME selector with "OFF" position N WHEN THE PROGRAMME SELECTOR IS TURNED THE DISPLAY LIGHTS UP TO SHOW THE SETTINGS FOR THE PROGRAMME SELECTED. FOR ENERGY SAVING, AT THE END OF THE CYCLE OR WITH AN INACTIVITY PERIOD, THE DISPLAY LEVEL CONTRAST WILL DECREASE. N.B.
TABLE OF PROGRAMMES Resistant fabrics Cotton, linen Cotton, mixed Mixed fabrics and synthetics Synthetics (nylon, perlon), mixed cotton Mixed, delicate synthetics Specials Very delicate fabrics Whites with Prewash TEMP.
59’ OFF 90° + Pre 30’ 60°C 14’ 40°C 30° & 50° EcoMix 20° 40° 30° 30° 30° Please read these notes * Maximum load capacity of dry clothes, according to the model used (see rating plate).
Programme selector For the various types of fabrics and various degrees of dirt the washing machine has different programme bands according to: wash cycle, temperature and lenght of cycle (see table of washing cycle programmes). RESISTANTS FABRICS The Cotton programmes are designed for maximum washing and rinsing efficiency. With spin cycles in between, the programme guarantees the laundry is rinsed perfectly. The final spin cycle ensures laundry is spun dry as much as possible up to the maximum speed.
SPIN & DRAIN The spin programme completes the spin at the maximum spin speed, this can be reduced by using the Spin Speed option button or excluded if you want drain only. SPECIAL “RINSE” PROGRAMME This programme carries out three rinses with a intermediate spin (which can be reduced or excluded by using the correct button). It can be used for rinsing any type of fabric, eg. use after hand-washing.
Detergent drawer P The detergent drawer is split into 3 compartments: - the compartment labelled "1" is for prewash detergent; - the compartment labelled " " is for special additives, fabric softeners, fragrances, starch, brighteners etc; - the compartment labelled "2" is for main wash detergent. NOTE: Some Detergents are Difficult to utilise. Ensure to use an in drum dispenser if recommended by the detergent Manufacturer. Note: only put liquid products in the compartment labelled “ ”.
Detergents, washing aids and amounts to use Choice of detergent General purpose detergents - - Powder detergents, for a thorough wash, with bleaching agent, particularly suitable for use in hot wash programmes (60°C and over), for heavily soiled and stained laundry. Liquid detergents, particularly suitable for grease stains, such as greasy skin marks, cosmetics and oil. These detergents are not suitable for washing stained laundry, as they do not contain bleach.
Dosages Only use detergents which are suitable for use in a washing machine. You will obtain the best results from your wash with the minimum use of chemical products and the best care for your laundry if you take into consideration the degree of soiling as well as the type of detergent to choose. The amount of detergent to use depends on: - water hardness: depending on the hardness of the water and the type of detergent used, it is possible to reduce the amount of detergent.
Useful advice for users Tips on using your domestic appliance in the most environmentally-friendly and economical way Do a full load in your washing machine To prevent any possible waste of energy, water or detergent we recommend that you put a full load in your washing machine, not exceed the recommended maximum load size.
Main wash Sorting the laundry - It is recommended you wash only items which are machine washable with water and detergent and not dry-clean items. - If you need to wash rugs, bedspreads or other heavy items, it is best not to spin them.
The correct way to wash Preparing the laundry A) Select the laundry. Loading the laundry B) Open the porthole. C) Put the laundry in the washing machine. Close the porthole again, ensuring that no items of laundry are obstructing the lock. Putting detergent in machine D) Open the drawer, choose the detergent and put in the correct amount, according to the manufacturer’s instructions and the advice on page 17. Add any other laundry aids (see page 17). Close the drawer again.
Cleaning and routine maintenance Do not use alcohol-based scourers and / or thinners on the outside of your washing machine, just a wipe with a damp cloth will suffice. The washing machine needs very little maintenance: - Cleaning the drawer compartments. - Cleaning the filter. - Cleaning the door glass. Cleaning the drawer compartments Even if it is not strictly necessary, it is good to clean the compartments for bleaching detergents and additives occasionally.
Attention: if the filter needs cleaning while there is washing still in the drum, follow the instructions on the following page to empty the water. This will prevent excessive loss of water via the filter. Cleaning the door glass Regularly clean the door glass with a damp cloth. A build up of soiling and residues from the water may result in water leaking from the door. Do not use abrasive cleaners as they can scratch the surface.
Investigating malfunctions What might be the cause of… Defects you can remedy yourself MALFUNCTION CAUSE REMEDY 1. Does not work on any programme Plug not in socket. Not switched on. Power failure. Fuse blown. Door open. Plug it in. Switch on. Check. Check. Close door. 2. Does not fill with water See cause 1. Tap turned off. Programme selector not correctly positioned. Fill hoses are kinked Check. Turn on tap. Position programme selector correctly. Straighten fill hoses 3.
Note: The use of environmentally-friendly, phosphate-free detergents can have the following effects: - waste water from rinsing may be cloudier because of the presence of zeolites held in suspension, without the rinse performance being adversely affected; - presence of white powder (zeolites) on laundry after washing, which is not absorbed by the fabric and does not alter the colour of the fabric. - The presence of foam in the final rinsing water is not necessarily an indication of poor rinsing.
Fig. 2 Technical data ■ Max. load of dry laundry ■ Water pressure 7 kg 8 kg 9 kg 0,05 ÷ 0,8 MPa 0,05 ÷ 0,8 MPa 0,05 ÷ 0,8 MPa Measurements ■ Width ■ Depth ■ Height 60 cm 52 cm 85 cm 60 cm 52 cm 85 cm 60 cm 58 cm 85 cm NB: For specifications regarding electrical data, see the data panel on the front of the washing machine (porthole area) - as shown in diagram above.
SETTING UP + INSTALLATION 1 Remove the polystyrene base and place the machine near its permanent position (diagram 1). Carefully cut through the hose retaining clip at the rear of the appliance (diagram 2). 2 Remove the 2 or 4 fixing screws marked (A) and remove the 2 or 4 spacers marked (B) (diagram 3). Cover the 2 or 4 holes using the caps provided in the instruction booklet pack (diagram 4). 3 4 WARNING: DO NOT LEAVE THE PACKAGING WITHIN REACH OF CHILDREN AS IT IS A POTENTIAL SOURCE OF DANGER.
Note: we recommend you keep the screws to immobilise the machine for future transit. The Manufacturers will not be responsible for any possible damage to the machine caused by not following the rules relating to releasing the mechanism. The user is responsible for all costs of installation. Water connection The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be re-used. The machine has an inlet hose with 3/4" B.S.
Note: it is advisable to turn off the tap after each wash to isolate the washing machine from the water supply. For the washing machine to function properly the terminal end of the discharge hose (mouth) must be at a minimum of 50 cm and a maximum of 85 cm from the ground. ELECTRICAL CONNECTIONS After installation, the appliance must be positioned so that the plug is accessible.
Recommendations on the use of detergent at various temperatures When washing heavily soiled whites, we recommend using cotton programs of 60°C or above and a normal washing powder (heavy duty) that contains bleaching agents that at medium/high temperatures provide excellent results. For washes between 40°C and 60°C the type of detergent used needs to be appropriate for the type of fabric and level of soiling.
gsfdgdhgfgj
This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used). It is important to have WEEE subjected to specific treatments, in order to remove and dispose properly all pollutants, and recover and recycle all materials.
