EN
WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used). It is important to have WEEE subjected to specific treatments, in order to remove and dispose properly all pollutants, and recover and recycle all materials.
in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. l Children should be supervised to ensure that they do not play with the appliance. l Children of less than 3 years should be kept away unless continuously supervised. l If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent.
l Do not expose the washing machine to rain, direct sunlight or other weather elements. Protect from possible freezing. and l The technical details (supply voltage and power input) are indicated on the product rating l When moving, do not lift the washing machine by the knobs plate or detergent drawer; during l Make sure that the electrical transport, never rest the door on system is earthed, complies the trolley. We recommend two with all applicable law and that people lift the washing machine.
2. INSTALLATION l Remove the 2 or 4 transportation screws (A) on the back and remove the 2 or 4 flat washers, rubber bungs and plastic spacer tubes (B) as illustrated in figure 1. l If the washing machine is built-in, unscrew the 3 or 4 transportation screws (A) and remove the 3 or 4 flat washers, rubber bungs and plastic spacer tubes (B).
Hydraulic connections EN 3 l Connect the water hose to the water supply tap (fig. 3) only using the hose supplied with the appliance (do not reuse old hose-sets). l SOME MODELS may include one or more of the following features: 4 l HOT&COLD (fig. 4): water mains connection settings with hot and cold water for higher energy savings. Connect the grey tube to the cold water tap and the red one to the hot water tap.
Setting 7 l The washing machine should be installed in its final position such that the water fill hose is not kinked or trapped. The corrugated drain hose should be inserted into suitable drain pipe of between 50 cm and 85 cm height above the floor using the curved drain hose support. If an under sink connection is used the drain hose must be routed above the sink overfill opening to prevent back siphoning. Care must be taken to avoid kinking or trapping the drain hose (fig. 7).
The detergent draw is split into compartments as illustrated in figure 9: 3 EN 3. DETERGENT DRAWER 9 l compartment "1": for prewash detergent; l compartment “ ”: for special additives, 1 softeners, starch fragrances, etc.; 2 WARNING: only use liquid products; the washing machine is set to automatically dose additives at each cycle during the last rinse. l compartment "2": for 10 washing detergent. A liquid detergent cup is also included IN SOME MODELS (fig. 10).
Maximise the load size 4. PRACTICAL HINTS l Achieve the best use of energy, water, Load tips When sorting laundry, make sure: - have eliminated metallic objects such as hair clips, pins, coins, from laundry; - to have buttoned pillow cases, closed zips, tied loose belts and long robe ribbons; - to have removed rollers, hooks or clips from curtains; - to have carefully read clothing washing labels; - to have removed any persistent stains using specific detergents.
- cloudier rinse drain water: This effect is tied to the suspended zeolites which do not have negative effects on rinse efficiency. For washes between 40°C and 60°C the type of detergent used needs to be appropriate for the type of fabric and level of soiling. Normal powders are suitable for “white” or colour fast fabrics with high soiling, while liquid detergents or “colour protecting” powders are suitable for coloured fabrics with light levels of soiling.
l Fill the drawer with hot water. 5. CLEANING AND MAINTENANCE Looking after your appliance correctly can extend its lifespan. Cleaning the appliance’s exterior l Disconnect the machine from the power supply. l Clean the appliance’s external cabinet, using a damp cloth and AVOIDING ABRASIVES, ALCOHOL AND/OR DILUENTS. Drawer cleaning l It is advisable to regularly clean the detergent drawer to avoid the accumulation of detergent and additive residues.
S u g g e s tio n s fo r m o v e s o r prolonged disuse l The appliance has a special filter that traps larger residues that could block the draining system, such as buttons or coins (depending on the model, consider version A or B). We recommend checking and cleaning the filter 5 or 6 times a year. l Disconnect the machine from the power supply. l Ensure all the water has been emptied from the drum.
6. QUICK USER GUIDE This washing machine automatically adjusts the level of the water to the type and quantity of washing. This system gives a reduction in energy consumption and a saving in washing times. 7. CONTROLS AND PROGRAMS M A Program selection l Turn on the washing machine and select the required program. L l Adjust the washing temperature if necessary and press the required "option" buttons. I B l Press the START/PAUSE button to start washing.
Don’t touch the display while inserting the plug because the machines calibrates the systems during the first seconds: touching the display, the machine couldn’t work property. In this case, remove the plug and repeat the operation. Close the door BEFORE selecting the button START/PAUSE. l Press to start the selected cycle. When the START/PAUSE button has been pressed, the appliance can take few seconds before it starts working.
l To delay the start use the following procedure: - AQUAPLUS l This option (available only in some - Select the required programme. - Press the delay start button once to activate it (h00 appears on the display) and then press it again to set a 1 hour delay (h01 appears on the display). The pre-set delay increases by 1 hour each time the button is pressed, until h24 appears on the display, at which point pressing the button again will reset the delay start to zero.
The machine is fitted with a special electronic device, which prevents the spin cycle should the load be unbalanced. This reduces the noise and vibration in the machine and so prolongs the life of your machine. 3 levels of wash intensity modifying the length of the programme, depending on how much the fabrics are soiled (can only be used on some programmes as shown in the table of programmes).
l Wait until the DOOR LOCKED light has KEY LOCK gone out before opening the door. l Pressing simultaneously the buttons TEMPERATURE SELECTION and SPIN SELECTION for about 3 seconds, the machine allows you to lock the keys. In this way, you can avoid making accidental or unwanted changes if a button on the display is pressed accidently during a cycle. l The key lock can be simply cancelled by pressing the two buttons simultaneously again or turning off the appliance.
10) Kg Detector (function active only on certain programmes) The indicator light show that the keys are locked. l During the first minutes of the cycle, the "Kg Detector " indicator remain on while the intelligent sensor will weigh the laundry and adjust the cycle time, water and electricity consumption accordingly. 8) WI-FI (some models only) l In the models with the Wi-Fi option, the icon indicates that the Wi-Fi system is working.
l Cycles – To download and launch new SMART TOUCH washing programmes. This appliance is equipped with Smart Touch technology that allows you to interact, via the App, with smartphones based on Android operating system and equipped with NFC (Near Field Communication) function. l Download on your smartphone Candy simply-Fi App.
NOTES: Place your smartphone so that the NFC antenna on its back matches the position of the Smart Touch logo on the appliance (as illustred below). l Every time you want to manage the machine through the App, first you have to enable the Smart Touch mode by turning the knob to the Smart Touch indicator. l Make sure you have unlocked your phone (from stand-by mode) and you have activated the NFC function; following the steps mentioned earlier.
Table of programmes 1) (MAX.) * PROGRAMME 2 (see control panel) (MAX.
INFORMATION FOR THE TEST LABORATORIES STANDARD PROGRAMMES ACCORDING TO (EU) No 1015/2010 e No 1061/2010 (Only for models with liquid detergent compartment) When only a limited number of articles have stains which require treatment with liquid bleaching agents, preliminary removal of stain can be carried out in the washing machine. Pour the bleach into the liquid bleach container, inserted into the compartment marked "2" in the detergent drawer, and set the special programme RINSE.
Description of programmes To clean different types of fabrics and various levels of dirt, the washing machine has specific programs to meet every need of washing (see table of programmes). Choose programme in accordance with the laundry instructions appearing on labels, especially the maximum recommended temperature. ECO 40-60 The ECO 40-60 programme is able to clean normally soiled cotton laundry declared to be washable at 40°C or 60°C, together in the same cycle.
colours together, with a full load, obtaining excellent results in only 59 minutes. With washing at medium temperature, this programme is recommended for laundry that is not particularly dirty. *Preset temperature of 20°C (modifiable Hygiene Plus 59' This programme offers the best possible combination of high temperature, time and cleaning action to guarantee maximum sanitising power against bacteria in only 59 minutes.
8. TROUBLESHOOTING AND WARRANTY If you believe the washing machine is not working correctly, consult the quick guide provided below which includes some practical tips on how to fix the most common problems. FOR SMART TOUCH MODELS The Candy simply-Fi app has a Smart Check-up function that allows you to confirm the functionality and status of the product at any time. To use the Candy simply-Fi app you will need an Android smartphone with NFC technology. More info can be found on the App.
Problem Possible causes and practical solutions The washing machine does not work / start The washing machine does not spin Make sure the product is plugged into a working supply socket. Make sure power is on. Make sure the wall socket is working, testing it with another appliance such as a lamp. The door may not be correctly closed: open and close it again. Check whether the required program was correctly selected and the start button pressed.
It is always recommended to use original spare parts, that are available at our Authorised Customer Service Centres. Warranty The product is guaranteed under the terms and conditions stated on the certificate included with the product. The certificate has to be stored so as to be shown to the Authorized Customer Service Centre in case of need. You can also check the warranty conditions on our web site.
fkhldsk
fkhldsk
fkhldsk
- CS/CSS M E - 20.10 - 43038539 - IDM s.r.l.
