User Manual

2.
DRAIN HOSE : FITTING
INSTRUCTIONS FOR TANK
IN DOOR DRAWER
To avod emptyng the water contaner after
each dryng cycle, the water can be dscharged
drectly to a waste water dran ppe (the same
dranage system as household snks). Water
Bye-Laws prohbt connecton to a surface
water dran. The waste water dran ppe should
be located adjacent to the tumble dryer.
The kt conssts of:1 hose and 1 tap.
WARNING! Switch off and remove the
tumble dryer plug from the electricity supply
before carrying out any work.
Fit the Hose as Follows:
1.Tlt the machne
backwards.
2. The waste water
ppe is situated at the
right-hand side of the
machine (see the
pcture). A grey hose
connects to the bridge
at the left hand sde of
the machne. Using
pliers, remove the
pipe retaining clip
from the bridge.
3. Pull the hose off the
bridge connection.
4. Attach the black
hose from the kit,
(using the connector
a n d p i p e c l i p s
supplied), to the hose
removed from the
bridge connection.
5 . P l a c e t h e t a p
suppled by the kt to
close the remang
hose.
Connect the new drain
hose to the waste
black water pipe .
6. Once the machne s
n place, check the
bottom to ensure that
the new hose does not
kink when pushing the
tum b l e d r y er i nt o
position.
Connect to the mains
electricity supply.
8
1
3
4
5
6
2