User Manual

5. WATER CONTAINER
The water removed from the laundry durng the dryng cycle s collected n a contaner nsde the
door of the dryer. When the contaner s full the ndcator on the control panel wll lght, and
the contaner MUST be empted. However, we recommend that the contaner s empted after each
dryng cycle.
NOTE: Very little water will collect during the first few cycles of a new machine as an internal
reservoir is filled first.
To remove the contaner
tank n door drawer
To remove the contaner
bottom water drawer
1. Gently pull out the
water contaner holdng
the handle. (A)
When t s full the
water contaner wll
wegh about 6 kg.
2. T  l t t h e w a t e r
contaner to empty the
water out through the
spout. (B)
When empty, replace
the water contaner
back as shown; (C) first
insert the base of the
container into position
as s h o wn (1) then
gentle push the top into
position (2).
3. Press Button to
restart the cycle.
NOTE: If you have the
opton of dranage near
to the dryer you can use
the dscharge kt to
provde a permanent
dranage for the water
c o l l e c t e d  n t h e
contaner of the dryer.
Ths means that you
don't have to empty the
water container.
A
B
1
C
10
1.Gently pull the bottom
of the kickplate so that it
unclips from the dryer.
The top section can
t h e n b e u n h i n g e d
allowing the kickplate to
b e c o m p l e t e l y
removed. (A)
2.Pull firmly on the
handgrip and slide the
water container out of
the dryer. (B)
Support the container
w i t h b o t h h a n d s .
(C)When full, the water
container will weigh
about 4kg.
3. Open the lid located
o n t h e t o p o f t h e
container and empty
the water.(D)
4. Refit the lid and slide
the water container
back into position. (D)
PUSH FIRMLY INTO
PLACE.
5. Refit the kickplate by
engaging the hinges at
the top and 'snapping'
the lower clips into
place.
A
B
C
D