Operating instructions

7
Silverware should be placed in the silverware basket with handles at the bottom: If the rack has side baskets, the spoon should
be loaded individually into the appropriate slots, Especially long utensils should be placed in the horizontal position at the
front of the upper rack.
Do not let any item extend throughbottom.
Teaspoons
4
Soup spoons
2
Forks
1
Serving fork
8
Serving spoon
6
Knife
5
3
Dessert spoons
7
Gravy ladle
When the knob stops turning and is aligned with a STOP mark(see figure), the cycle has finished .
Turn off the appliance using the ON/OFF button, shut off the water supply and open the door of
the dishwasher. Wait a few minutes before unloading the dish washer to avoidhandlingthe
dishes and utensils while they are still hot and more susceptible to breakage. They will also dry
better.
A forgotten dish can be added any time before the detergent cup opens.
Pull the door handle.
Do not open the door until the water spray action stops.
Steam may rise out of the dishwasher.
Add forgotten dishes.
Close the door and push the latch to the far right.
4
3
2
1
Make sure that the plug for the appliance is inserted into the wall socket.
Make sure that the water supply is turned on to full pressure.
Load the dishwasher(see the section entitled, " Loading the Dishwasher " ).
Pour in the detergent(see the section entitled, " Salt, Detergent and RinseAid").
Turn the knob located on the right of the control panel in the clockwise direction until the number or the symbol for the cycle
setting is aligned with the reference mark (see the section entitled, " Wash Cycle Table " ).
Press the ON/ OFF button, and the ON/OFF light will turn on. At this point, the wash cycle will begin.
2
3
4
5
6
Premise
: A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the detergent may
have already been released, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser
must berefilled (see the paragraph entitled " Loading the Detergent " ).
Press the ON/OFF button, and the ON light will turn off. Rotate the knob in the clockwise direction to the desired cycle setting (see
the section entitled, " Starting a wash cycle. . . " ). Then, turn the dishwasher back on using the on the ON/OFF button.
1
1
1
1
1
1
4
7
8
1
1
1
6
2
2
2
2
2
2
2
2
5
5
5
5
5
5
5
5
3
3
3
6
4
4
4
4
4
4
4
3
3
3
3
3