User Manual

21
5. For the last control, bring the burner both to higt-ame and reduced
positions and check whether the ame is on or off.
Depending on the type of gas tap used in your appliance the adjustment
screw position may vary.
To adjust your oven acc. to the gas type, make the adjustment for
reduced ame carefully by turning with a small screwdriver as shown
below on the screw in the middle of the gas cocks as well as nozzle
changes. (gure 6 and 7)
Removal of the cathedral burner
The burner protection sheet is xed with two screws. As shown in gure 8,
use a screwdriver to remove it. As shown in gure 9, press the spring clip
in the direction of the arrow to remove the burner from the slot. As shown
in gure 10, remove the injector in the bearing with a socket wrench. In
order to re-place the burner, apply the removal process reversely.
Figure 6 Figure 7
Figure 8 Figure 9 Figure 10