FRIDGE GB 1
FRIDGE DEFROSTING CONTROL PANEL In order to access and adjust the temperature of the fridge it is necessary to turn the knob on the control panel. The thermostat box is located inside the fridge on the top right handside. Important: If the room temperature is very warm, the appliance may work continuously and a layer of frost will deposit on the back of the fridge compartment. In this case it is necessary to turn the knob to lower settings The appliance is turned off when the knob is set to “0”.
REVERSING THE OPENING OF THE DOORS In order to reverse the opening of the doors, follow the indications in relation to the insert and hinge type your product is made up of. A Place the appliance on the floor or at a 45° angle, as it is necessary to work on the bottom of the appliance. Remove the lower plinth by pulling out the 3 protective plugs and by loosening the screws. Drill the plinth on the marked left hand-side area.
In order to reverse the opening of doors, disassemble the hinge at the bottom right Unscrew the hook located on the left side of the compartment Remove the outer caps as shown in the figure Insert the caps as shown in the figure Position the door and the hinge first, then screw the latter to the product Screw the hook on the right side of the compartment Turn the appliance back in vertical position and wait 2 hours before operating it 2 hours Z STUDIO > 01-2006 – 41018262
